Rollout Inline Beginner Guide: Grinds, Controls and Map Progression

Official Rollout Inline screenshot of a skater locking onto an outdoor handrail

The quickest way into Rollout Inline is to keep your first session small. Use the default spin controls, leave optional grind balance off, learn one two-foot grind on a low rail, and then complete the first map challenges. That route teaches the unusual dual-stick system while still earning the cash and map levels that drive progression.

This guide covers the Early Access launch version released on September 15, 2026. The game is still in active development, so check the current Controls screen after an update before assuming an old button layout still applies.

Set up the controller before learning tricks

Rollout Inline was designed around a controller. Connect yours before starting the game, then confirm that the on-screen prompts match the pad you are holding. The control pages can display the appropriate Xbox or PlayStation icons, which is much easier to follow than translating buttons while moving toward a rail.

Performance affects the skating more than it would in a turn-based game. The developer recommends adjusting graphics until the game holds at least 60 frames per second. If a DualShock or another non-Xbox controller behaves strangely, check Steam Input before remapping the whole game. An Xbox controller is the official recommendation for force feedback, but it is not the only supported way to play.

For a first session, resist the urge to move every physics slider. Leave the camera and grind magnet sliders where they are, use the default control scheme, and turn Grind Requires Balance off. This gives you room to understand jump timing and foot placement separately. Camera distance, camera height, grind magnet, minimum jump height and slow-motion speed can all be tuned later, once you know which part is actually causing trouble.

Give each stick one clear job

The left stick steers on the ground and handles spinning under the default layout. The right stick controls the jump. More importantly, both sticks become feet when you approach a grind: the left stick places the left foot and the right stick places the right foot. Hold the required directions before the skates meet the rail.

That last detail fixes many failed grinds. If you wait for contact and then move the sticks, the game may treat the input as late or lock you into a different position. Open Controls → Grind Controls, choose one simple two-foot entry, and use its animated preview. The list also separates left-foot- and right-foot-dominant versions, so check the full name instead of copying only the stick arrows.

Use a session marker beside a forgiving rail. The basic-controls page shows shortcuts for setting a marker and returning to it, which turns a long skate back into an instant retry. Make ten slow approaches from the same angle. Do not add a spin yet. Your first target is simply to jump, hold the grind input early, land near the middle of the rail, and roll away facing forward.

Learn one grind before attempting switch-ups

Once a grind has locked in, you can release both sticks. The skater stays on the rail, leaving your hands free to prepare the next position. Move the sticks into a second valid grind input to perform a switch-up. This feels much cleaner than holding the first combination while trying to twist directly into another one.

Build the sequence in three passes:

  1. Land the first grind and ride it to the end without changing anything.
  2. On the next attempt, release the sticks after the lock and re-enter the same position.
  3. Only then choose a second position from the Grind Controls list and switch once in the middle of the rail.

One-foot grinds use only the stick for the foot that is on the rail. They are easy to confuse when you are also steering, so learn them after a stable two-foot grind. If a combination looks awkward or clips through the skater, return to two positions that connect cleanly rather than forcing every possible input into one line.

Official Rollout Inline screenshot of a skater grinding inside The Big Hall
The Big Hall packs rails and ramps close together, which makes it useful for practicing short transfers and controlled switch-ups.

Add grind balance after the entry feels automatic

Grind balance is optional. When you enable Grind Requires Balance, the triggers correct your weight while you slide. You can also show a balance meter, change the balance intensity, or hide the meter and read the skater’s body instead.

Start with the meter visible. Watch how the character leans as the indicator drifts, then make small trigger corrections. Holding a trigger too long usually sends the balance past center and creates a second problem. Once you can keep the indicator near the middle without staring at it, hide the meter and use the skater’s hips and shoulders as the cue.

If you suddenly begin falling from grinds that were previously easy, pause and check the setting. It is possible to enable balance and then hide its meter, which makes every rail feel inconsistent until you remember that manual correction is active. A switch-up can also settle a bad-looking grind, but it should not replace learning the balance input.

Use cess slides and rolls to connect obstacles

A line becomes more interesting when the space between rails has a purpose. Cess slides use both shoulder buttons plus a grind input, so the same foot positions you learned on rails carry onto the ground. You can start the input while airborne and land directly into the slide, or slide toward an obstacle and jump into a grind.

Toe and heel rolls work like manuals and use a partial right-stick input. Keep the stick only halfway toward the required direction. Pushing too far can turn the attempt into a jump command. Pivots and quick 180s help correct your exit direction, especially after a spin leaves the skater rolling switch.

Practice these connectors on flat ground before placing them between obstacles. A useful first line is a short grind, a clean landing, one cess slide, and a pivot back toward the rail. It is not flashy, but it teaches you to finish each action before starting the next one.

Give grabs enough air and time the coping buttons

Air grabs only register while the skater is airborne. Small flat-ground hops often do not leave enough time for the animation to finish, so learn them on a quarter pipe or bowl. Hold the grab combination after takeoff, release it before the landing, and prioritize a level set of skates over an extra half-second of style.

Official Rollout Inline screenshot of a skater high above an outdoor bowl
Quarter pipes and bowls provide enough airtime to finish grabs without rushing the landing.

With the Xbox layout shown in the launch build, the right bumper handles flyouts and the left bumper handles stalls. Hold the flyout button as you reach the coping when you want to clear the lip or cross a spine. Hold the stall button with a grind input when you want a specific stall position. Pressing either shoulder too early during a Vert Roulette can accidentally turn an ordinary air into a flyout or stall, so keep your fingers relaxed until you have cleared the challenge’s requested trick.

Flips use vertical left-stick movement and can be combined with spins, but they punish poor landing angles. Learn a plain forward or backward flip first. Add rotation only after you can see the landing and stop the spin deliberately.

Let the first challenges teach you the map

Each map has its own challenge levels. Completing a batch raises that map’s level and reveals a harder set, while earlier challenges remain available for replay. Holding the map-progress button opens the checklist, so you do not have to skate from marker to marker just to remember what is unfinished.

The launch build shows several recurring challenge types:

  • Own the Spots names a trick and highlights the object where it must be landed.
  • Grind Roulette serves a sequence of grind requests. A fresh request appears after the current one is completed.
  • Vert Roulette does the same for airborne tricks on transition.
  • Collect all ROLLOUT Letters sends you through a timed route around the map.
  • Beat the Score rewards a clean, sustained line rather than one isolated trick.

Use the first level as a tutorial instead of chasing the largest multiplier. Grind Roulette is especially useful because it makes you read the foot inputs you would otherwise ignore. For the letter route, skate the whole path once without attempting tricks, then restart and collect it cleanly. During Own the Spots, read both the requested trick and the highlighted obstacle; landing the right grind on the wrong rail does not complete the objective.

Challenge rewards supply cash for clothing, and finishing a whole set awards a larger payment. Character items can therefore wait until you have cleared a few tasks. Skate parts are different: the official description says you can customize skates without progression unlocks. Frame and wheel choices shown at launch are cosmetic, so choose the look you want rather than hunting for a hidden speed advantage.

Choose a practice area that matches the skill

Early Access launched with three maps. The outdoor skatepark mixes bowls, rails and open flat ground, making it the easiest place to isolate a single input. Use a low handrail for grinds, a broad quarter pipe for grabs, and the open concrete for cess slides and rolls.

The Big Hall is denser. Its ramps, spines and rails sit close enough for lateral transfers, so move there when you can already land individual tricks and want to join them. The Observatory is a street-oriented map with long ledges, stair rails and wall-ride opportunities. It gives you more room to build a natural line, but failed attempts can leave you farther from the starting point. Set a session marker before working on a stair rail or wall.

Fix the mistake you can actually see

What happens Likely cause What to change
The skater misses or chooses the wrong grind The foot directions were entered after contact, or the approach was too far off-line Use a session marker, slow the approach, and hold one known grind input before reaching the rail
A grind starts correctly, then drops for no obvious reason Manual balance is enabled, possibly with the meter hidden Show the meter and make short trigger corrections, or disable balance while learning the entry
A grab does not animate The hop is too low or the input begins too late Move to a quarter pipe and hold the grab after takeoff
Vert Roulette keeps producing a flyout or stall A shoulder button is being held before the coping Release both shoulders until the requested air is clear of the lip
Spins end in sideways bails The rotation is still active at touchdown Return to the default spin layout, reduce the rotation, and watch the skates before landing
An Own the Spots trick will not count The right trick was landed on a different object Follow the highlighted obstacle as well as the prompt in the upper-left corner

If the controls feel broadly wrong rather than one trick failing, verify the current controller icons and Steam Input configuration. A bad device profile is not something that practice will fix.

Save the replay editor until you have one repeatable line

The replay editor includes follow-player and free-camera views, filters, lenses, keyframes and a hidden-UI option. It is tempting to open it after every surprising landing, but filming becomes much easier when the line starts from a session marker and follows a route you can repeat.

Official Rollout Inline screenshot of a skater holding a handplant in The Big Hall
A repeatable take gives the replay editor time to add a clean free-camera move, lens choice and keyframes.

Record the complete attempt, then place a wide keyframe before the first obstacle and a closer one near the main trick. Keep the camera on the landing long enough to show that the line was completed. A dramatic lens cannot rescue a clip that cuts away before the skates touch down.

Expect Early Access details to move

The launch package already includes three maps, map-specific progression, optional balance, difficulty settings, customization and a replay editor. It is still an Early Access game from a solo developer, and the developer has warned that bugs, crashes and unfinished behavior are possible. Treat exact balance values, prices, challenge lists and button assignments as current-build details rather than permanent rules.

The fundamentals are less likely to change: connect a controller before launch, keep the frame rate steady, read the in-game control preview, place each foot before rail contact, and practice from a session marker. Once those habits feel automatic, the game opens up from a list of inputs into the creative skating sandbox it is meant to be.

Source

Rollout Inline on Steam